The underneath clips are very easy to put back together just make sure you try to stretch it as far as you can get it.

On the other hand the clips between the seat and the middle console are a pain to get back in. Keep trying you'll get it. It takes a little bit of patience and really small hands. Try to use your second hand to pull the seat away from the middle console.

 

Yah. I got them back in. I was just surprised to see them off.


Sent from AutoGuide.com Free App

 

They may have been clipped in from the factory. Our pilot has been in 3 times to have the 2nd row seats clipped back in.

 

I have similar issue with the second row single seat leather not clipped in. I can clip it in but it will fell out in a few days. Is this normal? It doesn't seem right.

 

Update: I finally sent the car to dealership. They will order a new leather upholstery for free and replace it.

 

I have the same problem on my driver side front seat and the backside flap on the bottom. Are you supposed to "blindly" pull and stretch that clip until you find a horizontal "wire" ? Which one does it anchor to?

 

If you feel up under be seat it’s easy to figure out where the clip goes. There’s a little notch it fits into.

 

I looked underneath the Passenger side seat and that clip is set closest to the edge of the "grating" underneath. On the Driver side if I attach to the same equidistant edge it's a "loose" set, so Driver versus Passenger side the underside engagement points aren't the same. I would expect there to be symmetry between L and R sides.

 

i got the same problem for my passenger side seat. i just leave it hanging there .

 

Anyone able to stick a camera up there and show us where things should be?

 

It should stretch to the end of the elastic. Pull hard.

I’m going to be unrolling the passenger seat this weekend to install the aftermarket armrest on my passenger side. I’ll try to take a pic.

 

You know you could have just gone to the other seat and taken your own picture but here you go

 

Oh and if it’s loose there just tie a knot in it to tighten it up.

 

So then both the driver and passenger side clips attach to that last "wire" that's closest to you (or rearward towards back of car)?

Sent from my Pixel 2 XL using Tapatalk