Honda Pilot - Honda Pilot Forums banner

1 - 13 of 13 Posts

·
Registered
Joined
·
70 Posts
Discussion Starter · #1 ·
I was changing the o-ring and when i was tighteing the two bolds, one of them snapped and fluid went everywhere. I am having a hard time finding the part # on the diagrams for those two bolts seen in this picture, the L shaped gold thingie on the left (ignore the right red arrow)

this is a 2009 ex-l
137017
 

·
Super Moderator
2020 Honda Passport Touring AWD Metallic Steel
Joined
·
4,283 Posts

·
Registered
Banned from wife’s 2005 Pilot LX
Joined
·
3,841 Posts
Were you using a torque wrench when the bolt snapped? If no, then perhaps add one to your tool chest prior to round two with those bolts.
 

·
Registered
2009 Honda Pilot EX-L
Joined
·
10 Posts
I was putting mine back together and I snapped a bolt also. Ended up going to Grainger and probably paid more for some bolts that needed washers under them since they didn't have the exact length. I should have went to my Service Center for the parts. But when you need it NOW..... I did get lucky and the broken bolt came out easy enough. Best of luck to you!
 

·
Registered
Joined
·
9,475 Posts
1 - 13 of 13 Posts
Top