Honda Pilot - Honda Pilot Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
I'm replacing my front lower control arms on my 2011 Pilot this week. The service manual says I need to attach the bushing bracket to the control arm at an 8°+-1° Angle. It sounds like it gets torqued before installation. How have any of you managed to hold the angle in place while torquing it? Also, it seems weird that it would get torqued without the vehicle's weight. I would appreciate some direction.
 

·
Registered
Joined
·
12 Posts
I'm replacing my front lower control arms on my 2011 Pilot this week. The service manual says I need to attach the bushing bracket to the control arm at an 8°+-1° Angle. It sounds like it gets torqued before installation. How have any of you managed to hold the angle in place while torquing it? Also, it seems weird that it would get torqued without the vehicle's weight. I would appreciate some direction.
Did you ever find out how to gwt this done?
 
1 - 2 of 2 Posts
Top