[jfrano]

Has anyone installed this?
The rear Honda Emblem is particularly a PAIN. The 2 middle clips holding the rear plate section are hidden behind a metal plate. I couldn't get them!!

Anyone?

Thanks
Joe

 

[ChiefPilot]

This may help...

see instructions here... Good luck!

http://www.collegehillshonda.com/instructions/03pilot/goldkit.pdf

 

[jfrano]

Yes, I have those instructions.

The hangup is 13 on page 3. Is a CLIP REMOVER a generic tool that i can get? Two of the clips are cover by sheet metal with only about a 1 inch gap to slid your had inside, where there is about 5-6 inches to where the clips are!!!!!

 

[ChiefPilot]

Yes... I believe that a "clip remover" is an actual body shop tool.

I suppose that you could buy one at your local auto parts store. As an alternative, if I remember correctly, I think a small prybar would work nearly as well.