Air keeps getting into my power steering system new rack , pump and high pressure line don't see any leaks any where. I purge it several times works for a few minutes then start making noise again what else to be done.
I’m not sure what model the diagram link you posted refers to, but as you can see above, it doesn’t break down the PS pump. So maybe that’s why the culprit o-ring isn’t shown in this diagram.looking at this I am not seeing a return line o-ring on the pump, only a pressure side o-ring
https://www.hondapartsnow.com/resou...21/large/f34d821f4ce2ae894b779985aea93c9a.png
I'm pretty sure only the 1st gen Pilots PS pump had the inlet & outlet pump o-rings.
…
The 06-08 front wheel drive Pilots have the J35Z1 equipped with VCM@Huluobo apologies if you are aware of this, but this forum is for the '03-'08 Pilots, and you have an '09 or younger Pilot (based on the fact that you installed a VCMuzzler, which is N/A for the '03-'08.
--Chris N.
Hi pressure side would squirt out fluid, not suck in air. Don’t you think the same?Just to pile on to existing advice: frothy, milkshakey, air bubbly PS fluid is evidence of air entering the system. The most likely culprit is the high-pressure side O-ring. Start by replacing the fluid, the O-rings, and making sure you have the right fluid level.
--Chris N.