Honda Pilot - Honda Pilot Forums banner
1 - 3 of 3 Posts

·
Registered
2011 Honda Pilot, original owner
Joined
·
37 Posts
Discussion Starter · #1 ·
When setting the valve lash for a 2011 Pilot, what should the jamb nut(s) be finally torqued to, once you have the clearance correctly set? (0.20mm to 024mm on an intake valve, and 0.28 to 0.32mm on an exhaust valve), and are "done" with adjusting that valve?

(There are wonderful write-ups of the valve adjustment procedures here in the Piloteers website, but I couldn't find where the torque to final tighten to, was specified.)
 
1 - 3 of 3 Posts
Top